[. . . ] • Before cleaning or carrying out maintenance, switch off the appliance, disconnect the mains plug and turn off the water tap. • If a fault occurs, switch off the appliance and turn off the water tap. • The open dishwasher door can only support the weight of the loaded rack when pull out. Do not rest objects on the open door or sit or stand on it since the appliance may topple over. [. . . ] If crockery is prone to whitish streaks, reduce the dosage by turning the dial to a lower setting. If instead crockery is wet, increase the dosage by turning the dial to a higher setting. Rinse aid level indicator (visual or electric indicator depending on the model installed). Electric indicator: The indicator lamp on the control panel illuminates when the rinse aid dispenser is empty. Visual indicator: light = empty dark = full. 15 HOW TO FILL THE DETERGENT DISPENSER Only use detergents recommended for use in domestic dishwashers. If you use “new generation” enzyme-based detergents, select the Bio programmes which are also suitable for all normal detergents. If you use detergents in pellet form, follow the manufacturer's directions for use. The use of detergent in excess of the recommended dosage may cause pollution. For programmes with additional selected functions: “Half load”: load the upper or lower rack only. Use a smaller quantity of detergent. Normal load: For programmes with pre-rinse. (Example: Normal 65°C, refer to the “Wash programme chart”). For programmes without pre-rinse: • Pour the entire recommended dosage in the large compartment. If the recommended dosage on the detergent pack is over 45 ml, pour the remaining detergent in the small compartment. 16 HOW TO USE THE DISHWASHER Close the dishwasher door and turn on the water tap. Once set the programmed data cannot be altered by turning the programme selector knob or pressing the buttons. Note: Once the Start button has been pressed, the dishwasher memorises all the programme selected. To change the programme selected, press the Start button for about 5 seconds until the Start indicator lamp switches off. Select a new programme using the programme selector knob and press the Start button again. The End indicator lamp (if fitted) iIluminates briefly and the Start 4. Turn the programme selector knob anticlockwise to the “0” position (only after the End indicator lamp has switched on or the Start indicator lamp has switched off). Note: If the dishwasher is switched off during a wash programm, when switched on again the dishwasher resumes the wash cycle from where it was interrupted. Open the door and unload first the lower rack and then the upper one. 2 3 4 17 CONNECTIONS Refer to the separate installation instructions booklet. Water inlet and drain: • Strictly follow local Water Board regulations. • Make sure the inlet and drain hoses are kinkfree and are not crushed. • If the hose length does not suffice, replace with similar hoses obtained from your local dealer or our After-Sales Service. [. . . ] The appliance will not switch on: • Power plug properly inserted in the mains socket?To do this, turn off the water tap, disconnect the water hose, clean the filter, reconnect the water hose to the tap and turn on the tap. When loading large items in particular, make sure the water circulates and does not collect inside them. The Start indicator lamp flashes: Other fault signals on the model installed: End depending The programme progress indicator lamp on the control panel flashes: Detach the lower spray arm. [. . . ]